DUnit Output XE8 Vs XE10 Seattle

In XE10 Seattle the output of a DUnit test is changed.

In XE3 & XE8 I get this output:

DUnit / Testing
....FF
Time: 0:00:00.1

FAILURES!!!
Test Results:
Run:             6
Failures:        2
Errors:          0
There were 2 failures:
  1) [Unit1] TTesting3.TestCase3_1: ETestFailure
     at 
      "TTesting3.TestCase3_1, expected:  but was: "
  2) [Unit1] TTesting3.TestCase3_2: ETestFailure
     at 
      "TTesting3.TestCase3_2, expected:  but was: "

While in XE10 the output is:

Executing: "C:\Users\bart.coppens\Documents\Embarcadero\Studio\Projects\DUnit-XE3-XE10\DUnitXE3XE10.exe"
DataFiles: "C:\Users\bart.coppens\Documents\Embarcadero\Studio\Projects\DUnit-XE3-XE10\"
OSVersion: "Windows 7 Service Pack 1 (Version 6.1, Build 7601, 64-bit Edition)"

DUnit / Testing

TestFramework.TTestSuite.DUnitXE3XE10.exe 
StartSuite(DUnitXE3XE10.exe)(6) <
 TestFramework.TTestSuite.Test 1 
 StartSuite(Test 1)(2) <
  TestFramework.TTestSuite.TTesting1 
  StartSuite(TTesting1)(2) <
   Unit1.TTesting1.TestCase1_1 .
   Unit1.TTesting1.TestCase1_2 .
  > EndSuite(TTesting1)
 > EndSuite(Test 1)
 TestFramework.TTestSuite.Test 2 
 StartSuite(Test 2)(2) <
  TestFramework.TTestSuite.TTesting2 
  StartSuite(TTesting2)(2) <
   Unit1.TTesting2.TestCase2_1 .
   Unit1.TTesting2.TestCase2_2 .
  > EndSuite(TTesting2)
 > EndSuite(Test 2)
 TestFramework.TTestSuite.Test 3 
 StartSuite(Test 3)(2) <
  TestFramework.TTestSuite.TTesting3 
  StartSuite(TTesting3)(2) <
   Unit1.TTesting3.TestCase3_1 Failure: TestFramework.TTestFailure.TestCase3_1

   Unit1.TTesting3.TestCase3_2 Failure: TestFramework.TTestFailure.TestCase3_2

  > EndSuite(TTesting3)
 > EndSuite(Test 3)
> EndSuite(DUnitXE3XE10.exe)
Time: 0:00:00.1

FAILURES!!!
Test Results:
Run:             6
Failures:        2
Errors:          0
There were 2 failures:
  1) [Unit1] TTesting3.TestCase3_1: ETestFailure
     at 
      "TTesting3.TestCase3_1, expected:  but was: "
  2) [Unit1] TTesting3.TestCase3_2: ETestFailure
     at 
      "TTesting3.TestCase3_2, expected:  but was: "

Any idea how to get the same output in XE10 Seattle as in XE3 & XE8 ?